Nouveau Quad chez HK : X-4 FPV Fiberglass Quad Frame 485mm
Posté : jeu. 25 avr. 2013 15:02
Just when you thought that all multi-rotor frames looked the same...the X-4 FPV appeared on the scene and is breaking all the rules! Featuring fiberglass construction with ply reinforcement, the X-4 is super rigid yet lightweight. Its high gloss paint job is impressive to look at making it really stand out in the air.
This is the first purpose built fiberglass FPV multi-rotor frame on the market today and is very unique. It features a very large internal canopy space allowing for mounting of all your electronic components including your FPV system. It even provides mounting grooves for LED light strips on the bottom of the arms making it perfect to setup for night flying as well!
The unique fiberglass body design is beautifully finished and fully enclosed. It even includes top and bottom motor covers to hide all of the wires making for a super sleek and futuristic look.
The X-4 arrives mostly pre-built and with all necessary hardware. You will simply need to add your own radio system, brushless motors/ESCs, multi-rotor control board and lipoly battery.
Features:
• Unique full-body fiberglass construction
• Integrated clear canopy dome for FPV camera use
• Beautiful high gloss paint job
• Full body design makes for easy orientation while flying
• LED strip mounting grooves
Specs:
Width: 485mm (motor shaft center to center between front/rear arms)
Length: 685mm
Frame weight: 730g (w/out electronics)
Requires:
28-XX or 35-XX brushless outrunner motor x 4
25~40A brushless ESC x 4
10~12 inch propeller x 4 (2 standard/2 reverse rotation)
Multi-rotor control board
2200~3000mAh 3~4S lipoly battery
4CH transmitter and receiver
